Hardware:
- Size: 37x33mm (37×37mm with wings)
- Weight: ~14g
- Mounting: M3 20×20mm pattern
- Input: 3s-8s (absolute values 5v-40v)
- Current: 60A / ESC OUT (4x60A requires temperature attention)
- PCB nano-coating: Hydrophobic coating(protects components from water)
Features:
- Compatible with all Flight Controllers.
- Signal input: DShot 150/300/600/1200/2400, Bidirectional DShot & EDT 150/300/600, Analog PWM
- Telemetry: Voltage, Current, Temperature, RPM, mAh used.
Protections:
- Soft current limiting — smooth power reduction, never an abrupt cut
- Thermal protection — configurable temperature threshold with gradual rollback
- Stuck-rotor protection — detects blocked props before they damage the motor
- Shorted-FET detection at every boot — prevents powering a faulty ESC
- Winding short check — catches pretty damaged motor wiring before it matters
- Driver Fault protection — Voltara ESCs use smart gate drivers that can signal damage to the inverter parts or extreme current draw.
- Stall protection – reliably detects and restarts the motor following a stall event.
Available settings(Gen2 FW):
- Direction: Default NORMAL
- 3D / bidirectional mode: Default OFF
- Slow start: Default ON
- Startup power: Default MEDIUM
- Brake on stop: Default ON
- Ramp up: Default 100% (fastest)
- Ramp down: Default 100% (fastest)
- Timing advance: Default AUTO
- PWM frequency: Default AUTO
- Current Limit: Default 80A — when tripped, throttle reduced
- Temperature Limit: Default 100°C — when tripped, throttle reduced
- Stuck-rotor protection: Default ON
- Low RPM Protect: Default MEDIUM (1.09+)
- Beep volume: Default HIGH
- Beep mode: Default ALL
- Lost-model beacon timer: Default OFF
